Preview and loadout will be by appointment. For information contact Wayne at 701.430.1091 or Dave Benedict at Steffes Group, 701.238.5062.




LOCATION:  152 164th Ave SE, Hillsboro, ND 58045




PREVIEW & LOADOUT: By appointment


1993 Ford Versatile 946, CAH, air ride seat, 855 Cummins, 12 spd. manual, 4 hyd., Trimble EZ-Steer, LED lights, Michelin 520/85R42 factory duals at 98%, 5,150 hrs., S/N930236

1991 Case-IH 7130, MFWD, CAH, 18 spd. powershift, 3 hyd., power beyond, return flow, 3 pt., quick hitch, 1000 PTO, diff lock, (18) front weights,14.9R30 front tires, 14.9R46 hub duals, 5,920 hrs., S/NJJA0030231

1954 Farmall M, wide front, gas, 5 spd., 1 hyd., 540 PTO, 13.6-38 rear tires, S/NFBK8846



Trimble EZ-Guide 500 display, controller, wheel motor, A25 GNSS receiver



1994 Case-IH 1688, axial flow, 2WD, deluxe controls, fixed spd. feeder house, reverser, rock trap, ext. unloading auger, straw chopper, chaff spreader with quick release mounts, yield loss monitor, adj. rear axle, large and small wire concaves, Firestone 30.5-32 front tires, 14.9-24 rear tires, 3,920 hrs., dealer serviced annually, S/NJJC0121755

1998 Case-IH 1020 flex head, 25′, high dam, finger reel, poly, hyd. fore/aft, S/NJJC0318329

Case-IH 810 corn head, 8×22″, knife rolls, GVL poly snouts, Case-IH 1688 hookups, S/N012064

Shop-built header trailer



Unverferth GC650 grain cart, 14″ corner auger, Agri-Cover roll tarp, small 1000 PTO, 24.5-32 diamond tread tires, S/N650070



1993 White 6700 planter, 12×22″, 3 pt., lift assist, mechanical ground drive, Yetter manual adj. row cleaners, granular insecticide w/Lock-N-Load lids, Rebounder seed firmers, hyd. fold markers, SM 1000 monitor, corn/sunflower/soybean/sugarbeet plates, S/N606080



Case-IH 4900 vibrashank field cultivator, 42′, level lift hitch, 7″ spacing, 9″ sweeps, walking tandems across, 4-bar Summers Model 94 harrow, S/NJAG0066060

Ber-Vac 615, 29′, (4) rows of S-tines, (2) rows of crumbler baskets, S/N10751

Ber-Vac 615 center section

DMI 530B Ecolo-Tiger, (5) main shanks, (4) lead shanks, leveling discs, 16.5-16.1 tires, S/N722952

Case-IH 5600 chisel plow, 33′, level lift hitch, 12″ spacing, walking tandems across, 3-bar harrow, S/N072090

John Deere 100 chisel plow, 14′, 14″ sweeps

IHC 710 plow, 6×16″, semi-mount, coulters, S/N4584

TaskMaster tandem disc, 19′, folding, rock flex shanks, 9″ spacing, scrapers, 21″ blades

Melroe multiweeder, 10′, 3 pt.



Alloway stalk shredder, 22′, pull-type or 3 pt., L-knives, center drive gear box, small 1000 CV PTO, (4) rear 9.5L-15 tires, S/N25372

Brillion row crop cultivator, 12×22″, single shank 

John Deere 400 rotary hoe, 22′, 3 pt., cab guard, front gauge wheels

(2) band sprayer carts, 12×22″



1978 Ford 800 tandem axle, gas V8, Allison automatic with Hi/Lo, Midland 19’x96″x60″ steel box, twin post stabilized hyd. hoist, 3 pc. end gate w/grain door, roll tarp, diff lock, dual 50 gal. steel gas tanks, air brakes, Safe-T-Pull, mud scrapers, 11R22.5 tires on Dayton steel rims, 106,337 miles

1974 Chevrolet C65, tandem axle, 427 gas V8, 5&4 spd., Midland 19’x96″x60″ steel box, twin post stabilized hyd. hoist, 3 pc. end gate w/grain door, roll tarp, diff lock, Safe-T-Pull, mud scrapers, hand throttle, dual gas tanks, electric parking brake, 11R22.5 tires on Dayton steel rims, 90,000 miles, low miles on overhaul



Chrome Vac 510 grain vac, asst. straight & flex tube, cleanup kit, S/N87013143HSXNF

Scoop-A-Second auger, 61’x10″, mechanical swing hopper, hyd. up/down, 540 PTO

Westfield W70-31 auger, 31’x7″, 5 hp., 230v, 1 phase, S/N0480

Westgo takeout auger, 12′ inner flighting

Drill fill augers

Drill fill tender, dual bin, hyd. 5″ brush augers, roll tarp, S/N1120

Grain aerator & dryer screw-in vent tube, 115v, 2.4 amp fan, MRL 12″, 110v fan

Poly grain hopper

Dickey John Mini GAC grain moisture analyzer, S/N00-25114



1976 Ashland 60D dump-type scraper, 6 yds. heaped, bolt-on cutting edge, 10:00-20 tires, S/N13870

Miskin land leveler, 12′, 3 pt.



Woods S106 hyd. fold mower, 6′, 3 pt., 540 PTO

Pull-type mower, 6′, 540 PTO

Inland DA92 snowblower, 3 pt., 92″x36″, 28″ impeller, hyd. swivel spout, S/NP1036

1,000 gal. fuel tank, Gasboy 110v pump, shut-off nozzle

Briggs & Stratton Pacer 2″ poly pump, Solar 8 gal. poly rinse tank, misc. hoses & fittings

Baldor electric motor, 5 hp., 240v, 1 phase

(2) “Mud on Road” signs



Clarke 10 gal. sandblaster, wheeled poly abrasive container

(3) Pittsburgh Force pullers; Ridgid pipe threader

Hyd. jacks

Air compressor, 110 volt

Oil barrel pump, pail pump, Micro-Matic keg coupler and seed treater parts



Goodyear 14.9R46 tires on 10-bolt rims, (1) bad tire

(2) 11.25-28 single rib tires, 8-hole adj. center rims, 11″ inner hole

Implement tires, 9.5L-14SL 8-ply on 6-hole rims

10:00-20 tires

Tires including: Goodyear LT245/75R16 tires on 8-hole steel rim; Nanco 480/4-8 and Carlisle 4.8-8 tires on 4-hole steel rims; (2) Firestone 6.00-16 4-ply tires on 6-hole rims; Harley Davidson 18×8.50-8 tire; Armstrong 15×6-6 tire; Wilderness AT P265/75R16 tire; BF Goodrich P245/75R16 tire



WIC sugarbeet topper gear box, misc. parts, guide wheels, and guide mark ripper shanks

(2) Beet end gates

New flex head parts for Case-IH 1020

Corn head parts for IHC 810

Grain drill parts for IHC 6200; (2) electric motors

Cultivator shovels, S-tines, chisel points, and asst. hardware

Case-IH small 1000 PTO yoke, 1-1/4″x18″ square shaft, adj. link w/greasable ends

DMI shovels

IHC 3-1/2″x8″ hyd. cyl., 2500 PSI; Rockford 4″x8″ hyd. cyl., 2500 PSI; Misc. bearings, hyd. spacers, hyd. fittings

Large 1000 PTO driveshaft w/slip clutch, large 1000 splined at both ends, fits Alloway shredder

Hyd. cylinders: 4″x24″, 36″ pin to pin; approx. 2-1/2″ x14″, 21″ pin to pin

Small 1000 PTO driveshaft, 1-1/2″ ends, approx. 4′ collapsed length

Mower blades, counter clockwise rotation, 28″ to pin center

Hyd. hoses and belts

Misc. parts: bearings, pulleys, & sprockets

Quick coupler, 38″ inside, 42-1/2″ outside

Cultivator S-tines

3-wire extension cord, 145′+, used for 10 hp. electric motor, fuses, lights, 110 volt air compressor, cable clamps




or Dave Benedict at Steffes Group, 701.238.5062

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Miscellaneous Parts

in Farm Support Items

in Farm Support Items

in Farm Support Items

in Farm Support Items

in Grain Handling Equipment

in Grain Handling Equipment

in Applicators

in Grain Handling Equipment

in Mowing

in Tanks

in Tractor/Implement Tires

in Tractor/Implement Tires

in Truck Tires

in Truck Tires

in Miscellaneous Shop Equipment

Woods in Mowing

Unverferth in Grain Handling Equipment

Farmall in Tractors

Case-IH in Tractors

Case-IH in Combines

Case-IH in Headers

Case-IH in Headers

Shop-built in Trailers

Ford in Trucks

Chevrolet in Trucks

Westfield in Grain Handling Equipment

Case-IH in Tillage Equipment

Dickey John in Farm Support Items

White in Seeding Equipment

IHC in Tillage Equipment

Alloway in Mowing

DMI in Tillage Equipment

Ashland in Earth Moving Equipment

Trimble in GPS & Navigation Equipment

Case-IH in Tillage Equipment

Ford Versatile in Tractors

Melroe in Tillage Equipment

Case-IH in Miscellaneous Parts

IHC in Miscellaneous Parts

Goodyear in Tractor/Implement Tires

Inland in Snowblowers

Scoop-A-Second in Grain Handling Equipment

Ber-Vac in Tillage Equipment

Brillion in Tillage Equipment

Clarke in Miscellaneous Shop Equipment

Baldor in Farm Support Items

DMI in Miscellaneous Parts

John Deere in Tillage Equipment

John Deere in Tillage Equipment

Miskin in Earth Moving Equipment

WIC in Miscellaneous Parts

TaskMaster in Tillage Equipment

Chrome Vac in Grain Handling Equipment

Ber-Vac in Miscellaneous Parts

Briggs & Stratton in Tanks


Announcement: Information contained herein is presented on behalf of the seller. Steffes Group Inc., agent for the seller, cannot guarantee the information to be correct or assume the liabilities for errors and omissions. All lines drawn on maps are approximate. Buyers should verify the information to their own satisfaction. Any announcements made from the auction block on day of auction will take precedence over any matter of print and will be final.